KROHNE OPTISWITCH 4000C Contactless EN - Manual (Page 16)

1 2 3
4
Fig. 9: Connection valve plug - QuickOn DIN 43650
1 Compression nut
2 Cable
3 Split taper socket
4 Seal insert
5 Strand
6 Plug housing
The instrument is used for direct control of relays, contactors,
magnet valves, warning lights, horns etc. It must not be
operated without intermediately connected load, because the
electronic would be destroyed if connected directly to mains. It
is not suitable for connection to low voltage PLC inputs.
Domestic current is temporarily lowered below 1 mA after
switching off the load so that contactors, whose holding current
is lower than the constant domestic current of the electronics
(3 mA), are reliably switched off.
Contactless electronic switch
16 OPTISWITCH 4000 C - with contactless electronic switch
Connecting to voltage supply
31762
-EN
-060830