KROHNE IFC 050 Converter Quickstart EN - Manual (Page 8)

3
ELECTRICAL CONNECTIONS
8
IFC 050
www.krohne.com 08/2013 - 4002257402 - QS IFC 050 R02 en
3.1 Safety instructions
3.2 Important notes on electrical connection
DANGER!
All work on the electrical connections may only be carried out with the power disconnected. Take
note of the voltage data on the nameplate!
DANGER!
Observe the national regulations for electrical installations!
WARNING!
Observe without fail the local occupational health and safety regulations. Any work done on the
electrical components of the measuring device may only be carried out by properly trained
specialists.
INFORMATION!
Look at the device nameplate to ensure that the device is delivered according to your order.
Check for the correct supply voltage printed on the nameplate.
DANGER!
Electrical connection is carried out in conformity with the VDE 0100 directive "Regulations for
electrical power installations with line voltages up to 1000 V" or equivalent national
specifications.
CAUTION!
• Use suitable cable entries for the various electrical cables.
• The measuring sensor and signal converter have been configured together at the factory. For
this reason, please connect the devices in pairs. Ensure that the measuring sensor constant
GKL (refer to information on the nameplates) are identically set.
• If delivered separately or when installing devices that were not configured together, set the
signal converter to the DN size and GKL of the measuring sensor.