KANOMAX 1560 Multi-Channel Anemomaster Software Manual - Manual (Page 28)

27
2) Question message list
Name Message Title
Command
button
Cause
Input
confirmation
Value is not correct
Input again?
Input check 2 Input value is out of set range
or letters were input.
Confirm to
stop
measuring
Stop data take in? Multi-channel
ANEMOMASTER
soft ware
2 Displayed when click
measurement stop button.
Confirm to
change
parameter Change parameter? Displayed when finish setting
of module or probe.
Parameter is changed.
Save it? Displayed when you try to
make new, open, close or
finish after parameter was
changed. Confirm to
save file
There is data in memory.
Save it?
Multi-channel
ANEMOMASTER
soft ware
When take in data was not
saved and followings are
selected.
1) Make new, open, close, finish.
2)Set up or right before set up.
Confirm to
save over
other file
File of the same name exists
Save over it?
Save [###]
( ### : File name )
1
Displayed when you save file
and file of the same name
already exist.
* Command button
: 1 : “Yes” ,“ No”, “Cancel” three buttons
: 2 : “Yes” , “No” two buttons
: 3 : “OK” one button