KANOMAX 1560 Multi-Channel Anemomaster Software Manual - Manual (Page 27)

26
7.2 Message List
“Message” dialogue box consists from “Title” , “Message” and “Command button” as shown in Pic. 30.
Following is message list appears while this program is run.
1) “Caution” message list
Name of
dialogue
Message Title
Command
button
Cause
Value is not correct. Check input value Input value is out of set range or
letters were input.
[###] module is missing.
(### : Name of module) Input module type Input name of module is not
correct.
Settings of measurement
interval is 0.1～6553.5 sec.
Input
confirmation
MAX of measurement time
is XXXsec.
Set measurement
parameter
3
Input parameter is not correct.
Setting
confirmation
There is no set probe. Multi-channel
ANEMOMASTER
Soft ware
3 Confirmation will appear when
probe was not set before data
take in starts.
RS232C can not be opened.
Error occurred when close
RS232C.
Settings of RS232C is not
correct.
RS232C receive time-out. RS232C setting is not correct.
Timer of ANEMOMASTER : 5sec
Timer when data take in :10sec
There are omissions in
take in data.
Followings happened .
1) Take in data delimiter does
not corresponds to settings.
2) Sampling repetition time does
not corresponds to settings.
Data error occurred. Other data error occurred.
Numbers of
ANEMOMASTER
connected is not
corresponds to set value.
Numbers of ANEMOMASTER
connected does not corresponds
to settings.
Data buffer over occurred.
Data buffer over for
correspondence of PC occurred.
ANEMOMASTER
memory over occurred.
Memory over of main body of
ANEMOMASTER occurred.
RS232C
Error
Message
RS232C Correspondence
error occurred.
Multi-channel air
Velocity meter
Soft ware 3
Other correspondence error
occurred.
Print out
error
message Printer error. Multi-channel
ANEMOMASTER
soft ware 3 Printer error will occur while
printing if printer is not
connected or does not correspond
to Windows 95.
z
Command button : 3 [ ok ]