HT instruments HT9022 - Manual (Page 14)

HT9022
EN - 12
5. INSTRUMENT FUNCTIONS
5.1. PHASE DETECTION
With the selector switch set to “V ” (Voltage measurement) or “A ” (Current
measurement), by taking the end of the clamp jaw near an AC source, the red LED at the
base of the clamp jaw will turn on (see Fig. 1 – part 2), which indicates that current is
present.
WARNING
Phase detection is not active when the clamp selector switch is set to
“OFF”, “SETTINGS”, “W ”, “
Ω ”,“InRush A ”.
5.2. “SETTINGS” POSITION: INSTRUMENT SETTINGS
By positioning the selector switch to “Settings”, the screen aside
will appear, containing the possible settings of the instrument.
Press keys F2, F3 (T, S) to move the cursor and key F4 (OK)
to confirm the selected item. ▼ ▲
OK
G e n e r a l
D a t e / T i m e
L o g
I n R u s h
C o n t i n u i t y
19/01-17:00:00
5.2.1. General
By selecting “General”, the screen to the side will appear.
Press key F1 (Sel) to move the cursor and keys F2, F3 (T, S)
to change the selected item.
Press key F4 (OK) to save the changes made and go back to
the previous screen (see par.5.2).
• Language: the language of the clamp may be chosen
among: Italian, English, Spanish. German, Swedish, Danish,
Norwegian, French, Dutch, Portuguese, Finnish and Polish.
Sel
▼ ▲
OK
L a n g u a g e :
I t a l i a n
A u t o - O f f :
O F F
19/01-17:00:00
• Auto-Off : the auto power off of the clamp may be set to ON or OFF. If set to ON, the
clamp will switch off after 5 minutes after it is last used.
5.2.2. Date/Time
By selecting “Date/Time”, the screen to the side will appear.
Press key F1 (Sel) to move the cursor and keys F2, F3 (T, S)
to change the selected item.
Item “Format” allows selecting the date and time format between
EU (European) or USA (American).
Press key F4 (OK) to save the changes made and go back to
the previous screen (see par.5.2).
Sel
▼ ▲
OK
Y e a r : 1 1
M o n t h : 0 1
D a y : 1 9
H o u r : 1 7
M i n u t e : 0 0
F o r m a t : E U
19/01-17:00:00