Avaya R3.0 - Manual (Page 14)

Hardware Upgrade and Maintenance
14 Secure Services Gateway (SSG) Maintenance Guide
Replacing the hard drive in an x305 IBM server
This procedure consists of the following steps:
1. Removing the cover of the x305 IBM server
2. Removing the hard drive from the x305 IBM server
3. Installing the new hard drive in the x305 IBM server
4. Replacing the cover of the x305 IBM server
Removing the cover of the x305 IBM server
To remove the server cover:
Note:
Note:
Read General safety guidelines and Handling static sensitive devices .
1. With the server extended on the slide rails, loosen the 2 captive screws on the back of the
server that hold the top in place. See Figure 1 .
6 Power up the server Plug the power cords into the server and RSA. Press the
power-control button on the front of the server.
Note: Wait at least 3 minutes for the server to complete
its power up. Watch the power-on LED on the server
(the green LED is on steady).
7 Reconnect attached
devices Reconnect all attached devices, including the laptop and
the external flashcard reader (if used).
Table 2: Tasks for replacing the hard drive in an x305 or x306 IBM server (continued)
9 Task Description
2 of 2