Detcon Aluminum Junction Box User Manual
Page 5
Aluminum Junction Box
Detcon J-Box Instruction Manual
Rev. 0.0
Page 3 of 3
A 7/64” (2.77 mm) Allen screwdriver tool is required for lock/unlocking of threaded cover prior to
removal.
If the cover cannot be unthreaded by hand force, use a wide span wrench (grabbing knobs on cover) or use
a strap wrench (grabbing circumference of cover) to unthread cover.
When returning junction box to service, always tighten the cover down snugly until the O-ring seal is
compressed.
Maintenance
If threading of cover becomes difficult, apply small amount of non-volatile non-corrosive thread grease to
keep aluminium threads from locking up.
Replace this junction box if there are visible signs of significant corrosion on the metallic enclosure. Replace
the cover if there is any evidence of damage to glass lens. Replace the O-ring if it is damaged.
Avoid scratching of the exterior paint to maximize corrosion resistance. Do not submerge in liquids.
Minimize direct exposure to highly corrosive vapors and liquids.
Service & Warranty Information
Detcon Inc. warrants, under normal intended use, each aluminum condulet for a one year period under the
conditions described as follows: The warranty period begins on the date of shipment to the original purchaser.
The Detcon Aluminum Condulet is warranted to be free of defects in material and workmanship. Should any
Condulet fail to perform in accordance with published specifications within the warranty period, return the
defective part to Detcon, Inc., 3200 A-1 Research Forest Dr., The Woodlands, Texas 77381, for necessary
repairs or replacement.
Shipping Address: 3200 A-1 Research Forest Dr., The Woodlands Texas 77381
Mailing Address: P.O. Box 8067, The Woodlands Texas 77387-8067
Phone: 888.367.4286, 281.367.4100 • Fax: 281.292.2860 •