Detcon AV2-C1D1M - Manual (Page 5)

AV2-C1D1M
AV2-C1D1M Instruction Manual Rev. 1.5 Page 1 of 8
1.0 Description
Detcon Model AV2-C1D1M audio-visual alarm stations are designed for installation and use in hazardous
duty, corrosive work environments, UL listed for Class I, Division 1, Groups C and D. The alarm station
consists of two strobe lights and a siren.
The station can be wired to control circuit alarm devices for the purpose of warning personnel of hazardous
conditions. When used in conjunction with Detcon controllers, the alarm station is typically used to provide a
low alarm (strobe) and high alarm (strobe/siren) for pre-determined hazardous environmental gas levels (toxic
or flammable) as indicated by remotely mounted sensors.
The alarm station strobe lights may be configured with any combination of strobe colors such as amber, blue,
clear, green, magenta, or red. Dome guards are included. The rugged strobe lights are specifically designed
for hazardous locations or corrosive environments where a very bright visual signal is required.
1.1 Strobe
Figure 1 Strobe
Hazardous location strobe lights are available in voltage ratings of 24VDC, 120 VAC or 240 VAC.
The strobe light provides 85 high-intensity flashes per minute. The light meets Type 4X watertight, dust-tight,
and corrosion resistant requirements. It has an aluminum base coated for corrosion-resistance. The dome
guard fits over the glass dome to protect it against accidental collision with moving equipment.
Specifications
Strobe Voltage 24VDC, 120 VAC 50/60 HZ, 240 VAC 50/60 HZ
Mount Ceiling
Operating Current 1.9 Amps at 24 VDC, 1.14 Amps at 120VAC, 0.7 Amps
at 240 VAC
Strobe Colors Amber/Blue/Clear/Green/Magenta/Red
Dome Guard Included
Operating Temperature Minimum -55°C