DeFelsko PosiTector DPM v.3.1 Quick Guide - Manual (Page 7)

6
Standard models remain powered-up while in auto log mode.
The instrument will take readings for 40-50 hours on a set of
alkaline batteries, depending on the frequency of measurements.
Advanced models power down between readings to conserve
batteries. At each interval, the instrument will wake up, take a
reading, sync to PosiTector.net (if configured) and power down.
The instrument can record approximately 8,000 datasets while in
this mode using alkaline batteries, or approximately one dataset
every hour for eight months.
-Auto Log continues recording until memory is full, the instrument
loses power, or the user turns off Auto Log mode. Stored datasets
will remain in memory.
-To conserve battery life, readings update only at the Log Interval.
The last recorded readings will remain “frozen” on the display until
the next dataset has been stored.
-It is recommended that fresh alkaline batteries be installed prior
to an extended Auto Log.
NOTES:
Accessing Stored Measurements Data Accessing Stored Measurements Data
PosiSoft solutions for viewing, analyzing and reporting data:
PosiSoft USB Drive - connect the PosiTector to a PC/Mac using
the supplied USB cable to access and print stored readings, graphs,
photos, notes and screen captures. No software or internet
connection required. USB Drive (pg. 7) must be selected.
PosiSoft.net - a free web-based application offering secure
centralized storage of PosiTector readings. Access your data from
any web connected device. Go to: www.PosiSoft.net
PosiSoft Software - Desktop Software for downloading, viewing
and printing your measurement data.
PosiSoft Mobile (Advanced models only) - access readings, graphs,
capture photos and update annotations through WiFi enabled
devices, such as tablets, smart phones and computers.