Alarm mode, Setup menu – DeFelsko PosiTector DPM v.3.1 Quick Guide User Manual
Page 4

Standard models
will alert the user when the surface
temperature is less than 3°C (5°F) above the dew point
temperature. Enable by selecting the tick box.
The PosiTector DPM can automatically alert the user when
current climatic conditions exceed pre-set values. When selected,
the Alarm icon is displayed at the the top of the screen.
Advanced models
allow the user to set up custom alarm
conditions for each reading in a dataset.
Alarm Mode
Alarm Mode
Alarm
NOTE:
- Bluetooth Pairing info is cleared.
- Alarm settings are set to defaults.
- Menu settings are returned to the following:
Setup Menu
Setup Menu
Reset
Reset (soft reset) restores factory settings and returns the
instrument to a known condition. The following occurs:
- All batches and stored datasets are erased.
- Menu settings are returned to the following:
Memory = OFF
Auto Log = OFF
Bluetooth = OFF
Trend Chart = None
Units = Celsius
Flip Display = Normal
Auto Sync = OFF
Alarms = OFF
Alarm Sound = OFF
Wet Bulb = OFF
White on Black = OFF
Language = English
Battery Type = Alkaline
Backlight = Normal
Auto Log Interval = 5 min
Bluetooth Streaming = OFF
USB Drive= ON
Date, Time and WiFi are not affected by either Reset.
Perform a more thorough Hard Reset by powering down the
instrument, waiting several seconds, then simultaneously holding
both the center and (+) buttons until the Reset symbol
appears. This returns the instrument to a known, “out-of-the-box”
condition. It performs the same function as a menu Reset with the
addition of:
3