Catskill Craftsmen 54228 - Manual (Page 12)

STEP 12
A. Angle the Bottom Shelf as necessary
to pass it through the opening in the
cabinet top until it rests on the pins
installed in steps 2, 6, and 8.
STEP 13
A. Tap 1” pins into the 4 sets of holes in the
Back Panel.
B. Just above the Bottom shelf on the inside of
the Bottom Front Brace there are two sets of
holes. Tap 1” pins into these holes.
C. On the Inside face of the Top Front Brace
there is a hole adjacent to each of the magnet
blocks for the outside doors. Tap one 1” pin
into each hole.
D. Choose the height you want your
middle shelves, then tap the 2” pins in
accordingly on the Cabinet Dividers.
E. Slide the Cabinet Dividers
between the sets of pins in the
Back Panel and the pins in the
Front Braces until dividers rest
on the Bottom Shelf.
NOTE: Eight 2” pins are provided
in case you want the center middle
shelf & the side middle shelves at
different heights.
1” Pins
2” Pins
Divider
in place
Edge banding toward front of unit.