Catskill Craftsmen 1622 - Manual (Page 6)

STEP 7
Tools needed: medium Phillips
screwdriver
Hardware needed: (4) 2” machine
screws (bolts) and (4) nuts
Parts needed: Basic assembly
plus top support brace
Take the top support brace with the 2
pin holes and 4 nut access holes (larger)
facing down and align the pin holes with
the pins on the top edges of the swing
legs.
NOTE: These pins do not get washers!
If necessary, tap down on the top of the
brace to seat the pins. CAUTION!
Hammer down on a scrap of flat
wood or plastic so as not to mar
the top surface of the brace.
When seated, secure brace with
machine screws/nuts as in illustration 7
Illustration 7
Illustration 8
STEP 8
Tools needed: medium
Phillips screwdriver, hammer
Hardware needed: (8) 5/8” wooden
disks (small) and (4) 3/4” wooden
disks (large)
TIP: Use a piece of heavy paper to
hammer on instead of directly on
wooden disks.
Tighten all machine screws/nuts.
Tap in (4) 5/8” disks into each table
end/side and tap (4) 3/4” disks into
the bottom support brace as
shown in illustration 8.