Catskill Craftsmen 1622 - Manual (Page 5)

STEP 5
Tools needed: Hammer
Hardware needed: (4) 1 1/2” Steel pins (longest)
Parts needed: (2) Drop Leaves
Tap one 1 1/2” long pin into each end of both
drop leaves until seated. When seated, pin will
stick up about 3/4” out of the wood. CAUTION!
Don’t overdrive pins or wood will split!
OK if Pins are loose!
Illustration 5
STEP 6
Tools needed: None
Hardware needed: (4) washers
Parts needed: Basic assembly
plus 2 Drop Leaves
Gently spread the tops of the table
ends/sides apart and insert the drop
leaf pins (with one washer over each
pin) into the pre-drilled holes on the
top inside of the table ends/sides.
Place swing legs as shown in
illustration 6 to support the drop leaves.
Illustration 6