WEN 56100 Power Pro 2 Stroke 1000 Watt User Manual
Stroke 900 rated watt generator
Table of contents
Document Outline
- Item # 56100
- Owner’s Manual
- Manual del Propietario
- INTRODUCTION
- SAFETY INFORMATION
- GENERAL SAFETY PROCEDURES
- IMPORTANT SAFETY INSTRUCTIONS
- GENERATOR COMPONENTS
- ASSEMBLY
- Using the Generator for the First Time
- a. Oil
- To operate the engine, use a high quality 2 Cycle oil mixed with unleaded gasoline at a ratio of 32 to 1. See table below for mixing amounts.
- Note: Use NMMA or TC-WII or TC-W3 or JASO FB or FASO FC classified oil in the mixture.
- b. Gasoline
- Use unleaded regular, unleaded premium, or gasoline containing 10% ethanol. Fuel must be fresh and clean. Never use gasoline stored for long periods.
- Mixing Gasoline and Oil
- WARNING Never store generator with fuel in the fuel tank inside a building with potential sources of ignition such as hot water tanks, space heaters, clothes dryers, electric motors, etc.
- Notes: DO NOT mix gasoline and oil directly in the fuel tank
- USE NMMA or TC-WII or TC-W3 or JASO FB or JASO FC classified oil.
- Make sure fuel container is outside and in a well ventilated area.
- Fill the approved, clean red gasoline container with ¼ of the recommended gasoline amount.
- Add the required amount of oil to the gasoline.
- Tighten the cap on the fuel container.
- Shake vigorously to mix the gasoline and oil.
- Undo the fuel cap and add the remainder of the recommended fuel. Wipe away any spilled fuel or oil.
- Mixing Ratios: 32:1
- To 1 gallon gasoline, add 4 oz oil
- To 2 gallon gasoline, add 8 oz oil
- To 5 gallon gasoline, add 20 oz oil
- Step 2 - Filling the Fuel Tank
- Step 3- Ground the Generator
- Using the Generator for the First Time
- SUBSEQUENT STARTING OF THE GENERATOR
- USING THE GENERATOR
- MAINTENANCE / CARE
- STORAGE / TRANSPORT PROCEDURES
- SPECIFICATIONS
- EXPLODED VIEW
- WARRANTY STATEMENT