WEN 56100 Power Pro 2 Stroke 1000 Watt - Manual (Page 14)

11
To start your generator, perform the following steps:
1. No electrical devices should be connected to the generator during starting. Devices can
make it difficult for the engine to start.
2. Check that the generator is properly grounded (see “Ground the Generator”).
3. Check the fuel level.
4. Turn the fuel valve to the “on” position (see figure 4).
5. Move the choke lever to the “closed” position. (Move to far left position. See figure 5).
6. Set the engine switch to the “on” position. (Until the upper part of the rocker switch is
firmly depressed).
7. Pull on the recoil starter handle slowly until a slight resistance is felt. It is advisable to
place the hand not used in pulling the recoil starter on the generator to hold it in place.
Then pull quickly to start the engine. Return cord gently into the machine. Never allow the
cord to snap back.
8. If engine fails to start, repeat step 7. NOTE: After repeated failed attempts to start the
engine, please consult the troubleshooting guide before attempting again. If problems
persist please call (800) 232-1195 M-F 8-5 CST.
9. Once the engine has started, slowly return the choke lever all the way to the “open”
position.
10. Allow the generator to run for several minutes before attempting to connect any electrical
devices. This allows the generator to stabilize its speed and temperature.
Fig.4 - Fuel Valve Fig.5 - Choke
SUBSEQUENT STARTING OF THE GENERATOR
If this is not the first time using the generator, user should take the following steps to prepare it for
operation.
IMPORTANT: At this point the user should be familiar with the procedures described in the
section titled “Using the Generator for the First Time.” If the user has not yet read this
section, go back and read it now.