WEN 56100 Power Pro 2 Stroke 1000 Watt - Manual (Page 23)

20
TROUBLESHOOTING
IMPORTANT: If trouble persists please call our customer help line at (800) 232-1195 M-F 8-5
Central Time.
Problem Cause Solution
Engine will not
start Engine switch is set
to "off".
Set engine switch to "on".
Fuel valve is turned
to "OFF” position.
Turn fuel valve to "ON" position.
Choke is open. Close the choke
Engine is out of fuel Add fuel.
Engine is filled with
contaminated or old
fuel
Change the fuel in the fuel tank.
Spark plug is dirty. Clean spark plug.
Air cleaner is dirty. Clean or replace air cleaner.
Engine runs but
there is no
electrical output
Circuit reset button
is off. Wait for 2 minutes and push the circuit reset button to the "on"
position.
Bad connecting
wires/cables.
If you are using an extension cord, try a different one.
Bad electrical device
connected to
generator.
Try connecting a different device.
Generator runs but
does not support
all electrical
devices
connected.
Generator is
overloaded
Perform these steps: 1. Turn off all electrical devices.
2. Unplug all electrical devices. 3. Turn off generator. 4. Wait
several minutes. 5. Restart generator. 6.Try connecting fewer
electrical loads to the generator.
Short in one of the
connected devices. Try disconnecting any faulty or short-circuited electrical loads.