WEN 6502 4 x 6 Belt / Disc Sander - Manual (Page 8)

88
ASSEMBLY AND ADJUSTMENTS
ASSEMBLY
INSTALLATION OF SANDING DISC AND
GUARD
1. Peel backing away from sanding disc.
2. Align perimeter of disc with plate, and press disc
firmly into position on plate, leaving no loose edges.
3. Position disc guard against lower 1/3 of disc, align-
ing holes as shown. And use a screwdriver to fasten
the provided screws and washers securely.
MOUNT THE DISC SANDER TABLE
1. With the table in a horizontal position, line up and insert the pivot indexing pin with the pivot hole on the
frame. Hold in place.
2. Insert the handle into the threaded hole and tighten.
3. Adjust the table so that the edge is a maximum of 1/16 inch from the disc. Holding the table in this position,
tighten the three bolts on the top of the table.
WARNING: To avoid trapping the workpiece or fingers between the table and the sanding disc, the
table edge should be adjusted to a maximum of 1/16 inch from the sanding disc.