WEN 6502 4 x 6 Belt / Disc Sander - Manual (Page 10)

10
SANDING BELT TRACKING ADJUSTMENT
1. Plug in the power cord.
2. Turn the switch ON and OFF to make sure the
sanding belt is correctly centered and not sliding off
the idler and drive roller drums.
a. If the sanding belt moves toward the disc, slightly
turn the tracking knob counterclockwise.
b. If the sanding belt moves away from the disc,
slightly turn the tracking knob clockwise.
3. Turn the switch ON and OFF again; readjust the
tracking knob if necessary.
CHANGE SANDING BELT BED POSITION
The sanding bed can be used in the horizontal or vertical positions or any angle in between. To use in the vertical
position, do the following:
1. Loosen the bed locking screw with hex key, move the bed to the desired vertical position.
2. Tighten the locking screw when at desired position.
DUST PORT OPERATION
The dust port can be easily connected to a large diameter shop vacuum hose.
Sanding operations are inherently dusty. To help minimize the amount of dust that escapes into the surrounding
air, this sander is equipped with a 2-1/4” dust chute that can be easily connected to a dust-collection system. It is
strongly recommended that users employ a dust-collection system when using this belt & disc sander.
Use of a mask or respirator is still recommended even when a dust-collection system is in use.
INSTALL A NEW SANDING DISC
1. Remove the two screws from the sanding disc guard and remove the guard.
2. Remove the used sanding disc.
3. Wipe the sanding disc plate clean.
4. Peel the backing from the new sanding disc, align the disc with the
plate and press the sanding disc firmly on to the plate.
5. Reinstall the disc guard and tighten the screws.
ASSEMBLY AND ADJUSTMENTS