WEN 70751 10 Dual Bevel Sliding Compound Miter Saw User Manual
Page 16
16
Maintenance
WARNING: Always ensure that the tool is switched off and the plug is removed from the outlet before making
any adjustments or maintenance procedures.
Any damage to this tool should be repaired and carefully inspected before use, by qualified repair personnel.
Have your power tool serviced by a qualified repair person using only identical replacement parts. This will
ensure that the safety of the power tool is maintained.
Great Lakes Technologies, LLC will not be responsible for any damage or injury caused by unauthorized
repair or mishandling of the tool.
Power cord maintenance
If the supply cord needs replacing, the task must be carried out by the manufacturer, the manufacturer’s agent, or
an authorized service centre in order to avoid a safety hazard.
Cleaning
1. Keep the tool’s air vents unclogged and clean at all times.
2. Remove dust and dirt regularly. Cleaning is best done with a soft brush or a rag.
3. Re-lubricate all moving parts at regular intervals.
4. Never use caustic agents to clean plastic parts.
CAUTION: Do not use cleaning agents to clean the plastic parts of the saw. A mild detergent on a damp cloth is
recommended.
General inspection
Regularly check that all screws are tight.
They may vibrate loose over time.