WEN 70751 10 Dual Bevel Sliding Compound Miter Saw - Manual (Page 10)

10
Attaching the material support arms
The material support arms (14) help to support the material when working with long
workpieces. There are two location holes (15) for a support arm on either side of the
table. Loosen the lock knobs on the back of the base at the bottom. Ensure the support
arms are fully inserted before using them to support the workpiece (Fig. 10).
The material support arm locking knobs must be tightened to secure the support arms in
position (Fig. 11).
Trench depth adjustment
In its normal position, the trenching stop (37) permits the saw blade to cut right through a workpiece. When the
saw arm is lifted, the trenching stop can be moved to the left so that the trenching depth adjustment screw (36)
contacts the stop as the saw arm is lowered. (Fig.12).This restricts the cut to a “trench” in the workpiece. The depth
of the trench can be adjusted with the trenching depth adjustment screw (30) (Fig. 13) and locked in position with
the trenching depth lock nut (35) (Fig. 14).
Turning on and off
1. Depress lock off button (26) and pull switch trigger in (Fig. 15).
2. To turn the saw off release the on/off trigger switch (28).
Turning on the laser line generator
The laser line generator emits 2 intense narrow beams of pure red light to guide you as
you cut. It improves operator cutting vision, enables faster set-up, increases accuracy
and improves safety. To turn on the laser lines, press the laser light on/off switch (27)
(Fig. 16). To turn off the laser press the laser light on/off switch (27) one more time.