Walker Magnetics CER SERIES - Manual (Page 9)

9
O.S. Walker Inc., CER Lift Magnet
RULES
MODELS: CER-5 thru CER-20 & I/R-CER-5 thru I/R-CER-12
NEVER re-energize the magnet until it has been placed in contact with the load to
be lifted. Prematurely energizing the magnet could cause unwanted materials to
be attracted to the magnet.
PERSONAL INJURY MAY RESULT.
CAUTION
3
Position the magnet so the load remains level.
4
Energize the magnet by selecting the “ LIFT”
position. An indicator light will illuminate
when electrical power is applied to the
magnet. To obtain maximum lift, allow a few
seconds for the magnet to reach full power
before lifting load.
7
ALWAYS STAY
CLEAR OF THE LOAD.
Guide the load by pushing or pulling the edges.
This keeps your entire body clear of the load at all
times. DO NOT guide the load by pushing or pull-
ing the Magnet. NEVER get in a position where
you could get hit with load if it is dropped.
8
Carefully set the load down. De-energize
the magnet by selecting the “ DROP” posi-
tion. Hold for two to three seconds, when
released the magnet will return to the
“OFF” position. Then lift the magnet slightly
to be sure the load has been released.