Vitrex BT900SRIND - Manual (Page 5)

- 5 -
18 . Check damaged parts
- Before further use of tool, it should be carefully checked to determine that it will
operate properly and perform its intended function .
- Check for alignment of moving parts, binding of moving parts, breakage of parts,
mounting and any other conditions that may affect its operation .
- A guard or other part that is damaged should be properly repaired or replaced by an
authorized service center unless otherwise indicated in this instruction manual .
- Have defective switches replaced by an authorized service center .
- Do not use the tool if the switch does not turn it on and off .
19 . Warning
- The use of any accessory or attachment other than one recommended in this
instruction manual may present a risk of personal injury .
20 . Have your tool repaired by a qualified person
- This electric tool complies with the relevant safety rules . Repairs should only be
carried out by qualified persons using original spare parts, otherwise this may result
in considerable danger to the user .
21 . Caution!
- Please follow the instruction of PRCD to avoid affection of the tool by water .
- The inspection of hoses and other critical parts which could deteriorate and the
maximum permitted pressure of the water supply .
- Never use the tool without the PRCD delivered with the tool .
- Replacement of the plug or the supply cable shall always be carried out by the
manufacturer of the tool or his service organization,
- Keep water clear off the electrical parts of the tool and away from persons in the
working area .
TRANSPORTATION
• Before transportation, first to lock the cut unit by the locking system.
• This machine is equipped with one set of wheels
3 – SPECIFIC SAFETY RULES
• Ensure that the directional arrow marked on the diamond blade corresponds with the
rotational direction of the motor .
• With the machine disconnected from the power supply, rotate the diamond blade by
hand to ensure it is free from obstruction .
• Always keep the blade-securing bore and collars clean.
• Ensure that the blade-securing bolt is securely tightened.
• Never try to cut freehand. Always ensure that the tile to be cut is pressed firmly
against the rip fence .
• Ensure that the piece of tile that will be cut off has sufficient room to move sideways.
Failure to do so may result in the off-cut binding against the blade .
• Never cut more than one tile at a time.
• Never cut pieces too small to be held securely against the rip fence without leaving
enough space for the hand to be a safe distance from the diamond blade .
• Ensure that the table and surrounding area are clear with the exception of the tile to
be cut .
• Before cutting a tile piece, let the diamond blade run freely for a few seconds. If it
makes an unfamiliar sound or vibrates excessively, switch it off immediately and
disconnect from the power supply .
• Let the diamond blade reach full speed before start cut.
• Let the diamond blade come to a complete stop before removing any jammed or off