Triton MAKO 2000 Operation Manual - Manual (Page 37)

4-3
T RITON S YSTEMS , I NC .
S
ECTION
4 - H
ANDLING
C
ASSETTES
M AKO C ASH D ISPENSER O PERATION M ANUAL
3. Lift the cassette up slightly, so that its rear
bottom edge lifts free of the two alignment
pins on the top of the dispenser chassis. (See
Figure 4-2.)
4. Pull the cassette out slightly, so that you can
place your free hand around the front of the
cassette opening. This is the feed end of the
cassette. Apply pressure with your palm and
curl your fingers around the bottom front
edge of the cassette to prevent any remain-
ing notes from falling out. Slide the cassette
up and out of the dispenser chassis. (See Fig-
ure 4-3.)
If there are any notes remaining in the dis-
penser chassis, remove them by carefully
pulling them from under the pickup wires. If
necessary, turn the motor pulley manually to
eject any notes lower in the feedpath.
5. Transport the cassette to a flat work surface.
Remember to hold the cassette level, main-
taining constant pressure to any existing
notes to prevent them from falling out.
Figure 4-2. Lift cassette to clear the alignment pins.
Figure 4-3. Lift cassette from dispenser chassis.
Figure 4-4. Hold notes during transport.