Triangle Engineering of Arkansas Golf Fans HV 24 and 30 - Manual (Page 2)

Page 2
230/460/60/3 INSTALLATION
If supplied with 230 or 460 Volt Three Phase fan
m o t o r, your fan will re q u i re connection directly to
the power source since product is supplied with-
out a plug.
NOTE: ALTHOUGH THE FAN MOTOR IS THREE
PHASE, THE OSCILLATOR MOTOR IS SINGLE
PHASE AND WILL REQUIRE CONNECTION OF
TWO WIRES PLUS THE GROUND.
If power source is in a moist or wet area, all
components and connections must be water pro o f .
NOTICE: READ ALL INSTRUCTIONS
BEFORE STARTING ANY INSTALLATION AND WIRING.
ELECTRICAL WIRING
CAUTION
- If this product is to be use out-of doors or in areas
of extreme moisture, all electrical wiring and components must
be weather-proof or in moisture-proof enclosures and comply
with local and national electrical codes. Installation and wiring
must be done by a qualified person.
115/230/60/1 INSTA L L AT I O N
If your fan or fan/oscillator is supplied with 115 or 230 Vo l t
single-phase motors, it is recommended that a WEAT H E R -
P R O O F, GROUNDED electrical outlet be installed close to the
p roduct. This will permit the plug(s) furnished with the JetAire
to be conveniently removed should your fan re q u i re serv i c e .
PREPARATION
IN-GROUND INSTA L L ATION
WITH REMOVABLE POST:
• NOTE: It may be desirable to install electrical
through the center of the post. If so, this must be
done prior to installation of concrete.
• Prepare hole in ground as shown below. Depth
should be below frost line or a minimum of 24".
• Cut removable pipe to length and cut slot in bottom
as shown. Pipe may be any length to meet your
requirements. Before installing pipe, it should be
painted with a good grade of rust inhibitor.
• Install electrical and JetAire.
ROUND METAL POST:
• This installation requires the OPTIONAL "HMB 2430"
HORIZONTAL MOUNTING BRACKET.
• Using the proper size clamps for your specific column,
(clamps not furnished with bracket) mount Horizontal
Mounting Bracket as shown below.
• Once bracket is installed, proceed with electrical wiring
and installation of JetAire.
WOOD POST OR TREE MOUNT:
• For wood post or tree mount, it is necessary to pur-
chase the OPTIONAL "HTB 2430" TREE/POST MOUNT-
ING BRACKET.
• Install bracket at desired height above ground/floor
using 1 ⁄
2
" x 6" lag screws or 1 ⁄
2
" through bolts, washers
and nuts.
• Once bracket is installed, proceed with electrical wiring
and installation of JetAire.