Triangle Engineering of Arkansas TP HIGH VELOCITY FANS - Manual

RECEIVING, HANDLING AND STORAGE
Our TP Fans are carefully inspected before leaving the
factory. When the unit is received, on-site inspection should
be made. The unit is factory balanced, all components have
been tested prior to shipment. Units have been given an
operating and running test before leaving the factory. Units
which are mishandled can void the warranty provisions. If
units have been damaged in transit, it is the responsibility of
the receiver to make all claims against the carrier. Triangle
Engineering of Arkansas, Inc. is not responsible for damages
incurred during shipment.
Units should be handled with care to prevent possible
damage. Avoid jarring and/or dropping. Units which are
supplied with special painted or coated finishes should be
handled with care to protect the surfaces. If the continuity of
the coating is scratched and damaged due to mishandling,
the protective coating may be adversely affected.
Long term storage requires special attention. All units
should be stored on a level, solid surface (preferably
indoors). If outdoor storage is necessary, provide protection
against moisture and dirt. Protect all bearings and shafts
with lubricant and encase the entire unit in plastic or some
similar weatherproof material. To prevent deterioration of
lubricants, special finishes, etc., periodic inspections should
be made. During these inspections, it is good practice to
rotate the propeller by hand to spread bearing lubrication.
INSTALLATION
POSITIONING AND RUNNING POWER LINES: Normally,
power is brought up from within the building through proper
conduit lines to the proper connections.
TP HIGH VELOCITY FANS
INSTALLATION, OPERATING & MAINTENANCE
These instructions provide proper installation and
maintenance instructions for Triangle Engineering
products. Proper installation, operation and maintenance
will assure efficient and dependable performance. Improper
use or installation may result in personal injury or property
damage. Trained and experienced personnel should install
according to manufacturer’s instructions and in compliance
with federal, state and local government.
RETAIN THESE INSTRUCTIONS FOR FUTURE
REFERENCE. READ ALL INSTRUCTIONS THOROUGHLY
BEFORE PROCEEDING.