Triangle Engineering of Arkansas TPC 4815 - Manual (Page 2)

The TPC 4815 is a high volume portable fan
designed for heavy-duty use in factories,
warehouses, laundries, garages, etc. lt is
easily rolled to various locations on sturdy
10-inch diameter wheels. The unit is con-
structed of cold-rolled steel with a powder
coat finish. Guards are made of steel wire
and comply with OSHA guarding require-
ments. The ON/OFF switch is conveniently
mounted and guarded on side of barrel.
GENERAL SAFETY INFORMATION
1. Your TPC 4815 fan will operate only on
115 Volt AC, 60Hz (cycle) current with a
minimum of a 15 Amp circuit.
2. WARNING: To reduce the risk of electric
shock, DO NOT expose to water or rain. To
guard against electric shock while the fan is
connected to power source, DO NOT PER-
MIT fan to come in contact with other
grounded objects such as pipes, radiators,
ranges, etc.
3. DO NOT ABUSE POWER CORD. DO NOT
pull on cord to remove from electrical
receptacle. Keep cord away from heat, oil
and sharp edges. Inspect cord periodically
and replace if damaged.
IMPORTANT:
READ INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING
TO INSTALL, OPERATE OR SERVICE THIS FAN. FAILURE TO COMPLY WITH
INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY
DAMAGE. RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
4. Disconnect the fan when not in use, before ser-
vicing and cleaning and when repairing or replacing
parts.
5. DO NOT carry or move the fan when connect-
ed to power source. Be sure switch is in “OFF”
position prior to connecting to power source.
6. When the TPC 4815 is used out-of-doors with
extension cord, use only cord of proper size (Amp
rating), UL listed and with receptacle to accept three
prong grounded plug furnished on the fans power
cord. Only round jacketed extension cords should be
used.
7. Before operating this fan, check for worn or
damaged parts and replace or repair as required.
To avoid risk of fire, electrical shock or other
injury, disconnect from power source before ser-
vicing.
8. DO NOT operate the TPC 4815 near flammable
liquids or in gaseous or explosive atmospheres as
sparks from motor may ignite fumes.
9. If the wire guards are removed, replace before
normal operation.
10. In case of power failure, turn off the fan at
switch. This will prevent motor burn out and/or
unexpected restarting.
ASSEMBLY
There is no assembly required.
INSTALLATION
Simply locate fan in desired posi-
tion, connect power cord, and fan is
ready for operation.
OPERATION
Your TPC 4815 fan is turned ON or
OFF with a rocker switch located
toward the top of the barrel. To
operate the fan push the rocker
switch down on one side to turn the
fan ON and down on the opposite
side to turn the fan OFF.