Tennsco Q-Line Shelving Open - Manual (Page 5)

15. OPTIONAL Label Holder: Place the label
holder (Ref. No. 7) on the front edge of the shelf
and secure with three P-38F plastic tabs.
16. OPTIONAL Front Base Strip: Bolt front base
strip (Ref. No. 8) to the outside of the bottom
shelf with the three self-tapping screws provided.
Make sure that the ends of the front base strip
are behind the front flanges of the uprights.
13. Position the remaining shelf clips according to
your desired shelf heights, and place the
shelves over the clips. Keep in mind, while
placing the clips, that the hole pattern of two
round holes and then one square hole,
repeated every 3", can greatly help in aligning
the clips evenly.
PLEASE NOTE: Some shelves, depending
upon placement, could possibly require
temporarily removal of one end of a sway
brace in order to insert the shelf.
14. Tighten up all bolts and nuts on the rear and
side sway braces. There are fifteen bolts and
nuts to tighten, five for each pair of sway
braces.