Tennsco Z-Line Heavy Duty Boltless Rack - Manual (Page 3)

8. Attach shelf
reinforcements
(Ref. No. 4) at
each level by
sliding onto the
rivets until
centered. Tap
reinforcements
down until they
are seated firmly.
NOTE:
See chart on front
page for number
of reinforcements
recommended per
shelf level.
9. If particleboard decking (Ref. No. 5a) or wire
decking (Ref. No. 5b)
was purchased,
place the decking
on each shelving
level. The decking
should fit flat on
top of the shelf
supports and
reinforcements.
If you purchased
a single unit,
your shelving
unit is now
complete and
ready to use.
For adder units,
see step 10.
7. Attach the remaining channel beams at the same
levels you placed the
end supports,
making sure that
all are completely
seated in the
upright slots.
NOTE: If you
have purchased
additional shelf
levels, the end
supports and
channel beams
for the extra
levels may also
be inserted at
this time.
10. If joining more than
one unit together, your
original unit should have been
assembled with ZTP uprights on one end, as
described in step 5. Simply
continue adding shelf
supports and uprights
to complete your
additional units.