Star Lights Smart Light 2000 - Manual (Page 5)

‐ 5 ‐
minute. If the fixture again detects motion before the (1) minute is up, then the timer will reset, and the
count-down will recommence. If no other motion is detected, then the light will deactivate, and the area
around your coach will continue to be monitored. Finally, don’t be alarmed if the Smart Light 2000
™
does
not detect your motion at the exact same point each time. A variety of factors dictate when and at which point the
motion detection unit will activate the light bulb. If you have questions about this nuance, please contact our
engineering help desk for a more thorough explanation.
Starlights’ exclusive Star Monitor
™
continuously monitors the RV’s Battery Voltage Level. If the voltage drops
to the predetermined level, a RED LED will blink behind the clear plastic plug as a warning of a low battery
condition. Star Monitor
® will, in the auto mode, turn the Smart Light 2000 ™
fixture off. When the battery rises
past the predetermined level, the Smart Light 2000 ™ fixture will reset itself automatically and continue
operation.
Side note: Customers have asked why we deactivate the Smart Light 2000
™ at 11.5 volts. The reason is that at
this voltage level, most of your major appliances will cease to operate (such as your refrigerator) at which point
you will only have 30% of your battery left. Also, at 11.5 volts, your batteries are working at less than 35%
capacity.
The Smart Light 2000
™ has three (3) operating phases as listed below;
1. When activated in the “DAY-TIME Auto Mode” function, the Multi-Colored LED will blink
“BLUE”
2. When activated in the “NIGHT-TIME Auto Mode” function, the Multi-Colored LED will
blink “GREEN”
3. When the Smart Light 2000 ™
fixture is in either mode and the “Star Monitor
™ function” has
been activated by a low battery condition, the Multi-Colored LED will blink “RED”
LIMITED WARRANTY
This product is warranted free from defects in material and workmanship for a period of one year. If a defect in
material or workmanship occurs, call 1-800-883-5444 for instructions on how to have the defective product repaired, or
replaced, free of charge.
LIMITATIONS
 This warranty is extended only to the original purchaser of the product.
 This warranty only covers the assembled motion lighting fixture.
 Unauthorized service to, or modification of this product will void the warranty in its entirety.
 A purchase receipt or other approved proof of purchase is required before warranty service is rendered.
 This warranty is expressly in lieu of all other warranties, expressed or implied, including any warranty,
representation or condition of merchantability or that the products are fit for any particular purpose or use, and
specifically in lieu of all special, indirect, incidental, or consequential damages, including but not limited to, any
loss arising out of any breach of this warranty, as allowed by your state of domicile.
 This warranty gives you specific rights, and you may also have other rights that vary from state to state.
NOT COVERED
 Failure of the product as a result of an accident, abuse, negligence, alteration, or faulty installation, or any other
failure not relating to faulty material or workmanship.
 Reimbursement for inconvenience, installation, setup, time, loss of use, postage or unauthorized service
CAUTION: This unit should yield many years of quality service. However, to avoid damaging the Smart
Light 2000™ fixture’s, Fresnel lens and sensor, do not spray the Smart Light 2000 ™ fixture directly with a
high-pressure hose, or pressure washer.