SnowEx SP-8550 - Manual (Page 23)

© Trynex International 2010 1 — 26
Center High Mount Stop Lamp (CHMSL)
• With spreader mounted on vehicle, plug vehicle (CHMSL) harness into spreader stop lamp harness.
• Using supplied harness clamps and screws, route harness along side wall lower corner or so that harness will be out of
the way when spreader is in use.
• Locate vehicle ground wire and stop lamp power wire at rear of vehicle. Use supplied wire taps to connect harness to vehicle
electrical system. Once wire taps are installed, check to make sure stop lamp works when brake pedal is pressed. Properly
Model # SP-8550
complete installation by tying up any loose wires with ty-wraps, also add electrical tape over both connections to insure
a solid electrical connection. Some newer trucks have auxiliary stop lamp power leads already at the rear for these
types of applications.
CHMSL Spreader Harness
(installed on Spreader from factory)
Key Part No. Description Qty.
D 6158 #10 Lock Nut 2
D 6514 CHMSL Spreader Harness 1
D 6529 #10 Black Oxide Screw 2
CONNECT TO SPREADER LIGHT
HARNESS 2-CONDUCTOR PLUG