SnowEx Junior 325 - Manual (Page 22)

© Trynex International 2009 L1040 7 — 22
Operating the Spreader
E AR O
CAUTION – Sweep area clear of foreign objects or obstacles that could cause personal injury. Keep other persons, children,
or animals out of the area to be spread.
D OA G
WARNING – Do not overload vehicle. Use chart below to calculate weight of material. Weights of material are an average for
dry materials.
Material Weight Per Cubic Ft.
Rock Salt 75-85 lbs.
Sand/Salt Mix 95-120 lbs.
• Be sure to comply with manufacturer’s maximum gross vehicle weight ratings.
• Warning – Never leave materials in hopper for long periods of time as salt is hygroscopic and will attract atmospheric
moisture and harden up. When spreading sand mix, a 1:1 ratio for Sand/Salt mix is recommended to prevent the material
from freezing.
S D G
• Never exceed 10 m.p.h. when spreading.
• For a wider pass, increase spinner speed.
• You will need (2) 1/4-20 x 1/2” machine screws along with nylock type nuts.
• Install license plate with hardware to mounting holes provided in hopper apron.
• For a heavier pass, drive slower, or increase auger speed.
• Never operate spreader near pedestrians.
• Spread ice melters with the storm to prevent unmanageable levels of ice.
• Calculate spread pattern when near vegetation.
C SE A A O 25 10 5 1 7 f loc l l )
• See illustration below.
Mounting Holes