SnowEx SP-7000 Owners Manual - Manual (Page 10)

10 © TrynEx International 2014 F51537 REV-A141205
Troubleshooting
Spreader
PROBLEM POSSIBLE CAUSE SOLUTION
Motor doesn't run Loose electrical connections Check all connections
Motor seized Replace motor
Material not flowing from hopper Hopper is empty Fill hopper
Material is wet Replace with clean, dry, free-flowing mate-
rial
Frozen material Replace with clean, dry, free-flowing mate-
rial
Coarse material Replace with clean, dry, free-flowing mate-
rial
Auger loose on shaft Align/Tighten Coupler
Tighten bearing
Vibrator not working Check connections
Replace vibrator
Chute in up position Check/repair mechanical connection
Check/repair electrical connection
Bad actuator. Replace
Material free flows Chute in down position Check/repair mechanical connection
Check/repair electrical connection
Bad actuator. Replace
Poor spread pattern Spinner fins Adjust spinner fins