Assembly instructions – SnowEx SP-7000 Assembly Instructions User Manual

Page 5

Text mode
Original mode

STEP 9
Lower the tongue jack; pin in the vertical position. Remove the supports. Lower the spreader to rest on the tongue jack and the wheels.

STEP 10
Mount the fenders over the wheels.

STEP 11
Attach the ‘mud flap’ to the rear of the fenders. Use the clamp plate on the outside of the mud flap.

Assembly Instructions

STEP 12
Attach the spinner drive: lower the drive onto the pegs at the rear of the frame; secure with the two bolts and nuts from the hardware kit
through the hanger bracket. Plug it into the spinner plug on the side of the frame. Slide the spinner assembly’s hub over the motor shaft and
tighten the two bolts onto the ‘flat’ of the shaft.