Assembly instructions – SnowEx SP-7000 Assembly Instructions User Manual

Page 4

Text mode
Original mode

Assembly Instructions

STEP 4
Lift the spreader and support it to allow installation of the axle and trailer tongue. Once lifted, remove and discard the pallet. As a safeguard,
in addition to the support jacks underneath the spreader, leave the lifting device in place.

STEP 5
Fasten the Axle to the frame.

STEP 6
Mount the wheels, tighten the lug nuts.

STEP 7
Attach the tongue. It bolts directly to the frame and to the hitch mount at the front of the trailer. Connect the leads of the trailer harness to the
control board: Red to “BAT +” and Black to “GROUND”. Put the Hitch Pin and Hair Pin through the clevis.