SnowEx SP-1075X - Manual (Page 8)

© Trynex International 2012 (REV A) F50769 8
General Wiring Instructions
Model # SP-575X / SP-1075X
Step 1: Route Vehicle Harness Assembly and route from the rear of vehicle to front. Route harness along frame and attach to frame holes and
frame supports. It is not recommended to attach to fuel or brake lines for obvious reasons. Do not route close to exhaust system or
engine, even though Snowex uses high temperature wiring, it still could melt under extreme heat and short the spreader electrical
system, as well as the vehicle electrical system.
Step 2: Mount rear plug on bumper using supplied bolts, locate towards the center of the bumper to reduce the amount of debris it catches from
the tires. Important: Apply a small amount of dielectric grease to the plug.
Step 3: Secure harness from the rear to the front using heavy duty ty-wraps or frame clips along the frame and lighter duty ty-wraps everywhere
else.
Step 4: Find a location along the firewall where the Control Module can be attached. Mount Control Module to firewall with included hardware.
Step 5: Connect Harness to Control Module and to Vehicle Battery.
Step 6: Drill a hole in the firewall or use an existing hole; Route Data Cable from Control Module into the cab. Secure as needed to prevent the
Data Cable getting caught in moving parts.
Step 7: Plug Control Pendant into Data Cable. Push “ON” Button to test for power.
Step 8: Stick Hook-and-Loop (“Velcro”) to back of Pendant and to Dash.