SnowEx SP-1075X - Manual (Page 12)

© Trynex International 2012 (REV A) F50769 12
Troubleshooting
Model # SP-575X / SP-1075X
Spreader
Does Not Run
Controller Turns On
Beeps Shuts Off
Displays Error Code
On/Off Switch
Lights No Display
Nothing Happens
No Display
On/Off Will Not Light Up
OL Code
E1 Code
LB Code
All Other Codes
EO Code
Check Input Power
Check Power Source
To Controller
Definition
Amp Draw
Too High
Definition
Dead Short
In Motor Circuit
Definition
Bad Electrical
Connection
Check Harness
For Spliced In
Accessory
Definition
Open Circuit Between
Motor And Controller
Bad Controller
Check With Test Kit
Low Battery
Less Than 12 Volt
Output
Bad Controller
Check With Test KIt
Jammed Material
Corrosion
Break In
Wiring Harness
Check With Test Kit
Replace Affected
Components
Bad Motor
Check With Test Kit
Bad Controller
Check With Test Kit
Corrosion
Bad Controller
Check With Test Kit
Spreader Unplugged
Loose Connection
Bad Transmission
Check With Test Kit
Motor Power Cord
Disconnected
Inside Drive Assembly
Load Test Battery
Clear Jam
Replace All
Corroded
Connections
Replace Harness
Test 4 to 20 Amp Draw
No Load Good
Replace All Corroded
Connections
Replace
20+ Amp Draw
No Load Bad
Plug In Spreader
Tighten Or Replace
Test Turn Shaft
By Hand
Should Turn Freely
Open Access Cover
And Plug Together
Don´t Forget
Use Doelectric
Grease
Snowex Diagnostic Test Kit (STK-090) Is Available To Accurately Diagnose Any Issues With SnowEx Spreaders.
Call Your Dealer For Details.