SnowEx SP-100 - Manual (Page 8)

© Trynex International 2012 (REV 001) 8
Operating the Spreader
Model # SP-100
SPREADER LOADING
WARNING – Do not overload vehicle. Use chart below to calculate weight of material. Weights of material are an average for dry
materials.
Material Weight Per Cubic Ft.
Rock Salt 80-90 lbs.
Sand/Salt Mix 95-120 lbs.
• Warning – Never leave material in hopper for long periods of time as salt is hygroscopic and will attract atmospheric moisture and harden up.
SPREADER OPERATION
• Comes standard with electronic speed control and electric gate flow control kit.
• To start, select proper gate stop position, desired starting speed and switch control on.
• To open gate, engage switch to the left of the control on/off switch, to close gate dis-engage switch.
• You will need to adjust speed up or downto achieve a proper pattern when using different material types.
• If there are any problems while operating the spreader, refer to Troubleshooting Guide.
SPREADING TIPS
• Spread ice melters with the storm to prevent unmanageable levels of ice.
• Never exceed 10 m.p.h. when spreading.
• For a wider pass, increase spinner speed.
• For a heavier pass, drive slower or increase auger speed.
• Never operate spreader near pedestrians.
• Calculate spread pattern when near vegetation.