SnowEx SD-1400 Installation - Manual (Page 4)

4 © TrynEx International 2013 (REV B) F50729C
Safety
Before attempting any procedure in this book, the safety information in this manual must be read and understood by all personnel who have
any part in the installation, preparation, transport, service, repair or use of this equipment.
For your protection, safety and information decals have been placed on the spreader to remind the operator of safety precautions and par-
ticular hazards.
Remember it is better to have extra assistance and precautions in order to avoid injury.
Do not lift spreader by yourself, seek competent assistance before lifting spreader onto vehicle.
Park vehicle on level ground before installing the spreader.
Follow all vehicle safety information.
Only use the spreader in perfect condition and according to applicable regulations. Be aware of your sur-
roundings and alert to what you are doing to reduce hazards. You should always repair faults which could
influence the safety of the machine.
Personnel operating the spreader must read the Owner’s Manual before using – especially all safety
information. This includes people who occasionally work on or operate the machine such as for service and
transport. A clear understanding of how to operate the machine will reduce dangers involved with operating
powered equipment.
Keep all safety and hazard information for the machine complete and in readable condition. If the machine
is altered with regard to its safety or its operational behavior, stop operation immediately and report the
malfunction to the responsible department or person.
Personal protection equipment (PPE) must be worn to prevent accidental injury.
Rotating parts cause flying debris, wear safety glasses with side protection.
Use genuine SnowEx parts for replacement. These meet the specific technical requirements.
Suitable and adequate mechanic’s equipment is required for performing maintenance and service proce-
dures.
Keep all safety and hazard information for the machine complete and in readable condition. If the machine is
altered with regard to its safety or changes its operational behavior, stop operation immediately and report
the malfunction to the responsible department or person.
Use genuine SnowEx parts for replacement. These meet the specific technical requirements.
Adequate mechanic’s equipment is required for performing maintenance and service procedures.