ShelterLogic 58542 Run-In Shed 22 x 24 x 12 - Manual (Page 3)

Page 3
Basic Frame Assembly
STEP 1
STEP 2
Fit together an end rib using the following parts, (Fig.1) (1) #11136 3-Way Top Connector, (4) #11068 Swedged Rafter Pole, (2)
#11013 Side Bend Tube and (2) #11016 Bend Corner Leg. Using (8) 11131 5/16 X 2 3/4" bolts and (8) 690 5/16" nuts
securely fasten the joints of all parts. Lay this rib on the ground at the rear of your shelters designated location. For a 12'
tall building be sure to include the two foot extension pipe (4551).
NOTE: Be sure that all of the heads of the bolts are facing toward the outside of the rib.
Fit together the first middle rib using the following parts, (Fig.1) (1) #11135 Top Bend Tube, (4) #11068 Swedged Rafter Pole, (2)
#11013 Side Bend Tube and (2) #11019 Swedged Upright Tube. Using (8) #11131 5/16 X 2 3/4" bolts and (8) #690 5/16"
nuts. Securely fasten the joints of all parts. Lay this rib on the ground near the first end rib. For a 12' tall building be sure
to include the two foot extension pipe (4551).
Assemble the wind braces as shown in the
illustrations
(Fig.3 & Fig.4) .
Fig.1
10' Tall Frame 12' Tall Frame
10' Tall Frame 12' Tall Frame
Fig.2
Fig.3
Fig.4
Use 11131
5/16" x 2 3/4"
Bolts
11136
11068
11068
11013
11016
4551
Use 11131
5/16" x 2 3/4"
Bolts
11019
4551
11135
11068
11068
11013
Use 11131
5/16" x 2 3/4"
Bolts
11136
11068
11068
11013
11016
Use 11131
5/16" x 2 3/4"
Bolts
11135
11068
11068
11013
11019
STEP 3
For Basic Frame
For 12' Tall Building #648
#690
#11095
#11093
#648
#800053
#690
#648
#690
#11095
#11093