ShelterLogic 71534 Peak Style Storage Shelter 12 x 20 x 8 - Manual (Page 6)

Page 7
STEP 11: SECURE YOUR COVER
Fig. 11A, 11B, 12 & 13
Fig. 11B
corner leg
clamps
11130
690
11106
Fig.12
middle leg
clamps 11130
11107
690
Fig.14
Outside Corner View
Fig. 11A
Install the “S”-hook from the ratchet assembly into the legs of the
shelter. Pull the webbing carefully to remove the slack from the cover.
Be careful not to pull the webbing through the opposite side of the
cover. Insert the webbing through the spindle of the ratchet and pull
tight. Wind the ratchet until the webbing overlaps itself.
Repeat these steps on the opposite side. Repeat this on
the back side of the shelter. When all of the corners
are secured move the cover front to back so that it is
centered.When the cover is centered tighten all of the
ratchets. Do this in an “X” pattern to be sure it is
tightened evenly. Fig. 11A & 11B. When the cover is
tight from end to end install the 45” cover rails. Insert
the cover rails into the pockets of the cover. Clamp the
rails to the ribs using the 3-way and 4-way clamps as
shown in Fig. 12 & 13.
Check that the rails are evenly spaced above the
ground on both sides. Push down on the connectors,
one at a time, to tighten the cover. Tighten the bolts to the
cover in place and tight on the frame.
Check and tighten
Ratchets and Cross
Rails monthly to
ensure the cover
is tight.
COVER TIGHTENING TIP
CORRECT
INCORRECT
IS YOUR COVER
PULLED CORRECTLY
ON THE FRAME?
Fig. 11B
NOTE: ShelterLogic logo should line up on the left front and right rear corners near the top rail. If it is not legible and positioned
as shown above as “incorrect”, the cover has not been put on the frame correctly.
WARNING: Serious injury to persons or property could result if cover is installed and shelter is not completed and is left
unattended. Shelter must be anchored securely until completed.