SHARKOON Scorpio 2000 - Manual (Page 8)

scorpio 1000/2000
4. Installing a mainboard
1. Open the case by loosening the thumb screws on the case’s back
side and removing the left side panel. Lay down the case sidewise
on an even surface.
2. The mainboard’s mounting panel inside the case provides various
drillings to screw in the stand-offs (fig. 1).
fig. 1
The mainboard contains special screw openings (fig. 2).
fig. 2
Place the mainboard to the mounting panel. A stand-off must be
screwed into every drilling of the mounting panel visible through
the mainboard’s screw openings.
3. Remove the mainboard and screw the stand-offs into the respective
drillings of the mounting panel (fig. 3).
(Stand-offs)
fig. 3
4. Press the I/O shield (delivered with the mainboard) into the I/O
shield opening in the case’s back side.