Seed Hawk Ground Drive 2011 Calibration Guide User Manual

Page 8

Seed Hawk

Manual Calibration Guide

Step 3:

The screen now displays the number of revolutions

counted during the calibration. “Weight 10.00lbs” is highlighted.
Press the Toggle Button or Enter Key to enter the actual
measured value of the material weight in the catch bin. Press the
Toggle Button or Enter Key to accept the value.

NOTE: As this value is entered other values on the screen
will change as the monitor calculates the correct gearbox
setting to achieve the desired application rate for the
implement width and material density entered.

Step 4:

Close to the bottom of this window display is “Set

Gearbox to” and then the number. Set the gearbox to that setting
using the increase/decrease switch on the side mounted control
box.

Step 5:

Highlight the OK Option using the Selector Knob. Press

the Enter Key or Toggle Button to finish the calibration of this
meter.

Step 6:

Repeat steps 1-5 for each additional meter.

Note:

It is recommended to repeat calibrations to avoid operator

error.