Seed Hawk Ground Drive 2011 Calibration Guide - Manual (Page 4)

Seed Hawk
®
Manual Calibration Guide
3
Meter Settings
Meter Rate:
This value is automatically set during the meter
calibration procedure. It can also be set manually. Changing the
setting affects the displayed increments displayed. “Low” is for
application rates up to 10 Lbs/acre, “Medium” is for application
rates from 10 to 100 Lbs/acre, “High” is for application rates
above 100 Lbs/acre.
Low Alarm Point: This is the minimum meter RPM the monitor
will recognize. If the meter RPM falls below this setting an alarm
will sound and must be acknowledged if the condition is left to
continue. The default low alarm point value is 0.5 RPM. If this
value is to be changed, press the SELECT button and “0.5RPM”
will be highlighted and can be changed using the up/down arrow
keys. Once the desired value is on the screen press the SELECT
button again and the highlight bar will move to the “Weight/Rev”
bar. When seeding Canola or inoculants at slow speeds (less
than 4mph) slow speed alarm maybe triggered.
Weight / Rev: Monitor calculates and enters this value after
calibration is completed. Default is 0 for a new system.