Calibration procedure - pre-calibration – Seed Hawk LOUP III & VIPER PRO 2015 - Hydraulic Drive Calibration Guide User Manual
Page 13
SEED HAWK
®
2015 LOUP III & VIPER PRO™ HYDRAULIC DRIVE CALIBRATION GUIDE
8
Calibration Procedure - Pre-Calibration
Wing down pressure circuit must be active to operate hydraulic drive motors and meter gates (if equipped)
If operating an SCT
®
equipped machine, ensure meter gates are fully open for proper product flow
All Meters on Aircart must be individually calibrated. Calibrations must be done each time a crop is changed
Measure and record the weight of the empty calibration bucket
Calibration Bucket Weight: _________________
Continue to next page