SANDPIPER M10 Non-Metallic - Manual (Page 11)

M10nmdl1sm-rev0513 Models M10 Non-Metallic Page 9
This pump is pressurized
internally with air pressure
during operation. Always
make certain that all bolting
is in good condition and
that all of the correct
bolting is reinstalled during assembly.
WARNING
Before pump operation,
i n s p e c t a l l g a s k e t e d
fasteners for looseness
caused by gasket creep. Re-
torque loose fasteners to
prevent leakage. Follow recommended torques
stated in this manual.
CAUTION
When used for toxic or
aggressive fluids, the pump
should always be flushed
clean prior to disassembly.
WARNING
B e f o r e m a i n t e n a n c e
or repair, shut off the
compressed air line,
bleed the pressure, and
disconnect the air line from
the pump. The discharge
line may be pressurized and must be bled of
its pressure.
WARNING
IMPORTANT
Read these safety warnings
and instructions in this
manual completely, before
installation and start-up
of the pump. It is the
responsibility of the purchaser to retain this
manual for reference. Failure to comply with
the recommendations stated in this manual will
damage the pump, and void factory warranty.
WARNING
Airborne particles and loud
noise hazards.
Wear ear and eye protection.
WARNING
In the event of diaphragm
rupture, pumped material
may enter the air end of the
pump, and be discharged
into the atmosphere. If
pumping a product which is hazardous or toxic,
the air exhaust must be piped to an appropriate
area for safe disposition.
B e f o r e d o i n g a n y
maintenance on the pump,
be certain all pressure is
completely vented from the
pump, suction, discharge,
piping, and all other openings and connections.
Be certain the air supply is locked out or made
non-operational, so that it cannot be started
while work is being done on the pump. Be
certain that approved eye protection and
protective clothing are worn all times in the
vicinity of the pump. Failure to follow these
recommendations may result in serious injury
or death.
WARNING
Take action to prevent
static sparking. Fire or
explosion can result,
especially when handling
flammable liquids. The
pump, piping, valves, containers or other
miscellaneous equipment must be grounded.
WARNING
Important Safety
Information
Recycling
Many components of MARATHON ®
Metallic AODD pumps are made of
recyclable materials (see chart on
page 9 for material specifications).
We encourage pump users to recycle
worn out parts and pumps whenever
possible, after any hazardous pumped
fluids are thoroughly flushed.
Pump complies with EN809 Pumping Directive, Directive
98/37/EC Safety of Machinery. For reference to the
declarations of conformity visit: www.warrenrupp.com.