Rhino Shelter Steel Carport 12W X 20L X 8H - Manual (Page 7)

2. Join the End Bases (5) and Center Bases (6) together.
(See Figure B.)
3.
Using a tape measure (not included), take a measurement across the diagonals
of the frame to check it for squareness. Adjust the frame until the measurements
are equal.
(See Figure B.)
18’1/4”
DIAGONAL DIMENSIONS
SHOULD BE EQUAL
12’3-7/8”
SELF TAPPING SCREWS
(8)
FIGURE B
4. After you have completed all measurements and have the End Base (5) and
Center Base (6) Rails in place and squared, screw the joints together with two
Self Tapping Screws (8) per joint on the top surface of the Base Rails.
(See Figure B.)
Anchoring The End Bases And Center Bases To The Concrete Slab:
1.
To drill the anchor holes, you will need a hammer drill and a 1/2” diameter
concrete drill bit (neither included).
2.
Hold the Base Rails (5, 6) in place with your foot. Insert the 1/2” diameter con-
concrete drill bit through the anchor holes in the Base Rails and drill the holes
about
5” deep into the concrete slab. (See Figure C.)
FIGURE C
BASE RAILS
(5, 6) FIRMLY
INSERT TIGHTEN
CEMENT ANCHOR CEMENT
SO THAT WASHER ANCHOR
RESTS AGAINST NUT
BASE RAILS
DRILL HOLES
5” DEEP
INTO
CONCRETE
SLAB
SC071008JJ Please DO NOT return unit to store or dealer. For all questions or shortages please contact PAGE 7
Customer Service at: 800-447-7079 or 203-877-7070