Lincoln Electric IM596-1 PF-10_ZIPLINE BOOM PACKAGE - Manual (Page 12)

A-8 INSTALLATION
PF-10 / ZIPLINE BOOM PACKAGE
A-8
INSTALL THE 2” SPINDLE ASSEMBLY
With a 3/4” wrench, install the 2” spindle assembly
using the 1/2-13 x 3.00 bolt and washers provided.
Place the larger washer into the spindle assembly
before installation to the boom mast spindle bracket.
Line up the small hole on the spindle assembly with
the roll pin on the mast. After the 2” spindle assembly
is in place, completely tighten the bolt.
INSTALL THE GUN CONTROL PLUG
CABLE ASSEMBLY and
THE GUN AND CABLE ASSEMBLY
Install the provided gun control plug cable assembly to
the front of the wire drive assembly. Install the gun
and cable assembly per the instruction manual provid-
ed with the gun. Gun adapters may be required if
using a Non-Lincoln gun.
INSTALL THE WELDING POWER SOURCE
Install the welding power source per the instruction
manual provided with the power source.
INSTALL THE WIRE REEL, DRIVE ROLLS
AND GUIDES
Load the wire reel with a coil of wire so as to dereel off
the side of the coil closest to the conduit bushing.
Install the appropriate drive rolls and guides for your
specific wire size application per the instruction manu-
al provided with the wire feeder. Thread the wire
through the entire length of conduit to the drive rolls to
feed through the gun cable.