Lincoln Electric IM513 WIRE FEED MODULE - Manual (Page 27)

– – 27 –
M17220
#2 HEAVY LEAD
WIRE
FEED
MODULE
W.F.M. CONTROL PANEL
NEG. POS.
OUTPUT TERMINALS CONNECT TO POS. & NEG.
CONNECT TO NEG. BRUSH HOLDER
608
609
#2 HEAVY LEAD
#8 LEAD
NEGATIVE CV OUTPUT TERMINAL PANEL
MACHINE MUST NOT BE RUNNING WHEN MAKING THESE CONNECTIONS.
*
INLINE CONNECTORS
ON ENGINE WELDER REMOVE JUMPER PLUG FROM CONNECTOR AND CONNECT W.F.M. PLUG TO CONNECTOR ON ENGINE WELDER.
ENGINE WELDER
CONNECTOR JUMPER PLUG
W.F.M. PLUG
THERMOSTAT ASSEMBLY
CAUTION:
THIS UNIT IS PREASSEMBLED WITH A 250 AMP
THERMOSTAT ASSEMBLY. INSTALLING THIS UNIT INTO A CLASSIC 1 OR ANY 200 AMP MACHINE REQUIRES REPLACEMENT OF THE 250 AMP THERMOSTAT AS'BLY WITH THE 200 AMP THERMOSTAT AS'BLY PROVIDED IN THE MOUNTING HARDWARE PACKET.
WIRE FEED MODULE / ENGINE WELDER CONNECTION DIAGRAM
3-18-94
NOTE: This diagram is for reference only. It may not be accurate for all machines covered by this manual. The specific diag
ram for a particular code is pasted inside the
machine on one of the enclosure panels. If the diagram is illegible, write to the Service Department for a replacement. Give
the equipment code number.