Lincoln Electric IM649 Wave Designer - Manual (Page 12)

2.4 EQUIPMENT/SOFTWARE STARTUP
When the
Wave Designer software installation is complete, Wave Designer is listed among the
programs you can start up from the Windows startup screen. Click on START, point to the
programs option, then click on the
Wave Designer option. The Wave Designer Welcome
screen is displayed followed by the Pulse Waveform Editor screen. When the Pulse Waveform
Editor screen is displayed, the software is ready for use.
2-4 Section 2 SOFTWARE INSTALLATION
WAVE DESIGNER
Pulse Waveform Editor
Wire Feed Speed
Ramp Up Rate
Peak Amps
Peak Time ms
Tailout Time
Tailout Speed
Stepoff Amps
Backgrd Amps
Backgrd Time
Frequency
Ramp Overshoot %
26.4
33.4
21
40
.100
3.0
1.2
250
-20
600
Edit
Start
About
Adapt Short End
Wave Designer Pro Off Line - pulse.swf
700
600
500
400
300
200
100
0
0 3 6 9 12 15 18 21 24 27 30
File Tools Print Help
$
9
50
Off Line Stand by
Status AC.sco loaded
Adaptive
27850001
2.5 UPGRADE FIRMWARE
An ArcScope application is provided with Wave Designer Pro. In order to run the ArcScope
application, it may be necessary to upgrade the welding machine firmware. If the old firmware
does not support ArcScope, the ArcScope application will display garbled data rather than
waveforms.
Wave Designer will automatically detect the firmware version and prompt you to
upgrade the firmware if required.