Lincoln Electric IM988 SAE500 - Manual (Page 9)

A-2 INSTALLATION
SAE-500™
A-2
Read this entire installation section before you
start installation.
SAFETY PRECAUTIONS
Do not attempt to use this equipment until you
have thoroughly read all operating and mainte-
nance manuals supplied with your machine. They
include important safety precautions, detailed
engine starting, operating and maintenance
instructions and parts lists.
ELECTRIC SHOCK can kill.
•Do not touch electrically live parts
such as output terminals or internal
wiring.
•Insulate yourself from the work and
ground.
•Always wear dry insulating gloves.
------------------------------------------------------------------------
ENGINE EXHAUST can kill.
•Use in open, well ventilated areas or
vent exhaust outside
•Do not stack anything near the
engine.
------------------------------------------------------------------------
MOVING PARTS can injure.
•Do not operate with doors open or
guards off.
•Stop engine before servicing.
•Keep away from moving parts
------------------------------------------------------------------------
Only qualified personnel should install, use or
service this equipment
LOCATION/VENTILATION
The welder should be located to provide an unrestricted
flow of clean, cool air to the cooling air inlets and to avoid
restricting the cooling air outlets. Also, locate the welder
so that the engine exhaust fumes are properly vented to
an outside area.
DO NOT MOUNT OVER COMBUSTIBLE SURFACES
Where there is a combustible surface directly
under stationary or fixed electrical equipment, that
surface should be covered with a steel plate at
least .06”(1.6mm) thick, which should extend not
less than 5.90(150mm) beyond the equipment on
all sides.
------------------------------------------------------------------------
STACKING
These machines cannot be stacked.
ANGLE OF OPERATION
To achieve optimum engine performance the machine
should be run in a level position. The maximum angle
of operation for the Kubota engine is 20 degrees con-
tinuous in all directions and 30 degrees intermittent
(less than 10 minutes). If the engine is to be operated
at an angle, provisions must be made for checking and
maintaining the oil level at the normal (FULL) oil capac-
ity in the engine crankcase. When operating the welder
at an angle, the effective fuel capacity will be slightly
less than the specified 29 gallons.
LIFTING
The equipment lift bail should be used to lift the
machine.
• Lift only with equipment of adequate
lifting capacity.
• Be sure machine is stable when lift-
ing.
• Do not lift this machine using lift bail
if it is equipped with a heavy acces-
sory such as a trailer or gas cylinder.
FALLING • Do not lift machine if lift bail is
EQUIPMENT can damaged.
Cause injury. • Do not operate machine while
Suspended from lift bail.
------------------------------------------------------------------------
WARNING
WARNING
CAUTION